Awhile back, I shared the plans for our staircase makeover. It’s a project that’s been long overdue, and I’m so excited to finally be making progress. As a reminder, here’s the overall look we’re going for (although ours is a little more closed in)…
Getting rid of the dingy carpet was fairly simple aside from pulling out countless staples. I guess that’s easy for me to say since my husband and son took care of it all. They’re both really good at the destruction part of a renovation. Guys seem to enjoy breaking things, don’t they?
After that, we were still left with the orange-y red stain on the handrails and bottom part where the posts get screwed in. I thought about painting it the white trim color, but I didn’t think it would hold up well over time. Somehow, I knew stripping it down to the bare wood wasn’t going to be a walk in the park, but I was willing to try.
Unfortunately, anything related to painting and staining is often handed off to me. Not because they’re incapable, but I tend to be more detail oriented. Plus, I grew up on a farm where one tends to get a lot of experience in the painting and staining department to say the least.
Stripping the Wood
On one of my many trips to Home Depot over the course of this renovation, I came across a biodegradable furniture stripper called Bio Option that seemed like a safer alternative to some of the toxic ones that are readily available. Being sensitive to chemicals, I thought I’d give it a whirl.
We removed the handrails and took them out to the garage where I had an old folding table lined with plastic and brown paper. I applied a generous coating of the stripper with an old paint brush to each one. Even though the product didn’t have a harsh smell, I wore disposable gloves and a mask just to be safe. I also kept the garage door wide open for proper ventilation.
Each stain finish is different, of course, but allowing the product to sit for an hour or so before scraping with an old putty knife seemed to work best. I believe this wood had stain plus a clear coat or two, so it was a bit tough coming off. On some difficult areas, I had to apply the wood stripper twice and ended up using steel wool to get into the grooves.
To clean up the excess, the instructions said to use paint thinner. I wasn’t too keen on it, but I did find one from the same brand that was low odour, which seemed to work well (mask and gloves, of course).
For the rest of the wood, I had to finish it inside. At first, I left the iron spindle part attached to the base (because I was home by myself and was too impatient to wait for my husband to come home to help), so I ended up taping everything off and tackling it that way. When you have someone coming to install the trim in two days you have no other choice, right?
Again, it took two coats of wood stripper and a lot of passes with the scraper and steel wool to remove the finish. And, again, I used a bit of the paint thinner to clean it up.
To get it down to the bare wood, we ended up removing the railing and using an orbital sander starting with 100 grit paper and finishing off with 180 grit.
Staining the Wood
For the stain, I used Minwax® Wood Finish in espresso. I simply brushed it on, waited a bit, then removed the excess with a rag.
I was hoping to get the finish as close in color to the new hardwood we selected, but it turned out a bit darker. This wood is red oak, whereas our floors are wire brushed white oak. (You can see a bit of a pink undertone on the bare wood.) Plus, each piece of wood takes stain differently depending on the grain.
To me, it looks so much better than what was there. Once the hardwood treads go in, I’ll be able to tell if the color needs a little tweaking. I’m holding off staining the handrails until I see how it all looks together. Hopefully I won’t need to paint over it all in the end!
Have any experience stripping and staining wood? If so, I’d love to find out more tips to speed up the process or get a beautiful finish.
Be sure to follow along on Instagram to see behind-the-scenes renovation progress pics.
Thanks for stopping by!